Thank you for choosing Gunstreet. below is the instructions for a Volume Bleed Wiring to be installed in your Les Paul.

lp how to volume bleed.jpg

Switch Install


1520382486759.jpg

Switchcraft Output Jack

Solder the Wire labeled "O" to the section labeled "0" on the switch diagram above

Solder the Wire labeled "N" to the Right Lug Labeled "N" on the switch diagram above

Solder the Wire labeled "B" to the Left Lug Labeled "B" on the switch diagram above

Solder the Black Wire with no label to the Middle single Lug Labeled "G" on the switch diagram above


Installing Pickups

 PIckup name Key H1=Hot Output G1=Ground


1470946942-picsay (2).png

IMG_3792.JPG

Bridge Volume: Bridge Pickup Install-Part 1

Solder the Hot Pickup wire to the First Lug on the potentiometer.  See diagram on the left. If not sure which wire is hot please refer to your pickups manufacturers instructions



Bridge Volume: Bridge Pickup Install-Part 2

Next, Solder the pickups Ground to the casing of the Volume Pot.


IMG_3793.JPG

Repeat these steps for the Neck Volume

IMG_3795.JPG
IMG_3797.JPG

IMG_3798.JPG
Las Paul bridge ground.jpg

Grounding the Harness

Solder the Ground Wire coming from your guitar bridge to the casing of any pot. In the this the Volume was the Closest


That's It!